> There's a new version of ReplicatorG available, v0040 : To install Sailfish Thing-O-Matic Firmware 4.1, Cupcake firmware 3.5, you will need a MakerBot with either Gen 4 electronics or Gen 3 electronics and a 3G5D Shield or "Ugly Cable Hack." Their contact email is: for Installing Sailfish Firmware for Thing-o-matics and Cupcakes Sailfish Firmware is authored by MakerBot Operators jetty and dnewman. All Cupcake firmwares should be considered experimental. We've also posted a Sailfish update for the 3G 5D shield for Cupcakes. Sailfish Firmware implements acceleration for the Thing-O-Matic and Cupcake and greatly improved interface features for operators with the interface kit. We've also merged support for Sailfish firmware, and we're hosting Sailfish builds so that you can upload them directly from ReplicatorG 40. This version supports the Replicator 2 and has built-in support for using Skeinforge 50 with the Thing-O-Matic. If you try it out, feel free to provide feedback in this thread or to. We're offering this to the MakerBot Operators a few days before posting it for general users. * bugfix for commiting oboard preferences to Thing-O-Matic * bugfix for commiting onboard preferences to Replicator(Single Extruder) * Added support for accelerated Thing-o-matic firmware. * Added Profiles for Thing-o-matic with Skeinforge-50 and volumetric printing
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |